Preparing your printer for the first use is important to ensure proper functioning of the device and making the whole printing process easier. The following steps show how to properly unpack and set up the machine. This article also shows how to install the firmware and software as well as how to carry out the platform and nozzle calibration procedures. 

1

In the Box

inventure_unpacking-06.png

The graphic shows the whole box content.

2

Preparing the Printer for Work

inventure_preparation-01.png

Open the box and remove the cushioning.

inventure_preparation-02.png

Remove the boxes with accessories.

inventure_preparation-03.png

Use the handles to take the printer out of the box. The handles are on both sides of the housing.

inventure_preparation-04.png

Remove the security foil.

inventure_preparation-05.png

Open the top door and remove the plastic foams holding the extruder.

inventure_preparation-06.png

Insert the build tray into the printer and set the safety locks to the vertical position. Close the front door.

inventure_preparation-07.png

Plug in the power cable and turn on the printer.

inventure_preparation-15.png

From the menu choose “Material,” then “Model” and “Load the model material.” Follow the instructions provided on the display.

inventure_preparation-17.png

Open the left door by pressing the release buttons.

inventure_preparation-16.png

Insert the model material cartridge on the left side of the printer and turn the lock to CLOSE. Close the side door.

inventure_preparation-09.png

From the menu choose “Material,” then “Support” and “Load the support material.” Follow the instructions provided on the display.

inventure_preparation-10.png

Open the right door by pressing the release buttons.

inventure_preparation-11.png

Insert the support material cartridge on the right side of the printer and turn the lock to CLOSE. Close the side door.

inventure_preparation-12.png

From the menu choose “Maintenance” and then “Platform Leveling.” Follow the instructions provided on the display.

inventure_preparation-13.png

From the menu choose “Maintenance” and then “Nozzle Alignment Calibration.” Follow the instructions provided on the display.

3

Firmware Installation

inv_firmware.png

Download the latest update of firmware at Zortrax Support in the Downloads section.

To install the firmware, copy the InventureUpdate.bin file to an SD card, insert the card into the printer and turn on the machine.

The firmware updates automatically.

4

Z-SUITE Installation

Z-SUITE_home.png

The latest Z-SUITE version can be found at Zortrax Support in the Downloads section.

To download and install Z-SUITE, you can enter the serial number of your printer or your e-mail address. To find the serial number, go to “Information” tab in the menu and choose “Serial Number.”

5

Cartridge Installation

From the menu choose “Material,” then “Model/Support” and “Load the model/support material.”

Open the side door by pressing the release buttons.

Insert the model material cartridge on the right side of the printer and the support material cartridge on the left side. Turn the lock to CLOSE and close the side door.

6

First Print

inventure_preparation-14.png

Insert the SD card into the slot. Your printer is now ready to print.

firstprint_inventure.gif

To choose the model for printing, select “Models” option from the main menu.

Select the model and confirm by pushing the button.

The printing procedure will begin automatically.

The display will show information about the extruder heating level. Once the heating is completed, the Inventure will start the printing process. The bar on the display will show the progress of the printing.

Do not leave the printer unattended during the pre-print calibration.

Was this article helpful?

Yes No

Thank you for your feedback.

Arrow back Arrow up