Packing of the M200 needs to be dealt with carefully as the fragile elements of the printer may get damaged during the process or shipment. While sending your printer to the technical service, follow these steps.

NOTE! It is not required to send the printer together with the side covers because there is a risk that they can get damaged during transport. They are also not necessary for proper servicing.

Unplugging the Power Cable

Unplugging the Power Cable

Turn off the printer, unplug the power cable and wait until the printer cools down.

Unplugging the Extruder Cable

Unplugging the Extruder Cable

Unplug the extruder cable.

Removing the Platform

Removing the Platform

Unplug the heatbed cable. Both big and small connectors need to be unplugged. Remove the platform from the printer.

Lifting the Heatbed Mount

Lifting the Heatbed Mount

Lift the heatbed mount.

Placing the Starter Kit Box

Placing the Starter Kit Box

Put the platform into the Starter Kit box and place the box on the bottom of the printer.

Placing the Accesories Foam

Placing the Accesories Foam

Place the printer accessories in the accessories foam. Put the foam with the accessories on the Starter Kit box inside the printer, then lower the heatbed mount so that the box and the foam are tight and secured.

Setting the Extruder in the Right Position

Setting the Extruder in the Right Position

Move the extruder manually to the end of X axis and then to the end of Y axis so the extruder is placed at the top right corner of the printer. Put the shipping clips on both axes.

Placing the Fillers

Placing the Fillers

Place the fillers on the boxes.

Wrapping the Printer

Wrapping the Printer

Wrap the printer in foil.

Placing the Bottom Cushioning

Placing the Bottom Cushioning

Place the cushioning at the bottom of the box.

Putting the Printer into the Box

Putting the Printer into the Box

Place the printer on the bottom cushioning inside the box. Be careful not to damage the knob next to the display.

Placing the Top Cushioning

Placing the Top Cushioning

Place the top cushioning on the printer so that it fits the extruder.

Packing the Printer

Packing the Printer

Pack the printer safely using the provided box.

Taping the Box

Taping the Box

Tape the box.

Was this article helpful?

Yes No

Thanks for your feedback.